|Frequency:||50Hz/60Hz||Phase:||Three Phase Four Wire|
Multi Tariff 1P Din Rail KWH Meter Active Energy Measure Multi Function CT
Model RDK100SCR single phase electronic multi-rate DIN rail active energy meter is a kind of single phase two wire two tariffs (tariff conversion is controlled by timer outside or similar equipment) active energy watt-hour meter.
The meter completely accord with relevant technical requirements of class 1 single phase active energy meter stipulated in international standard IEC 62053-21.
It can accurately and directly measure 50Hz or 60Hz active energy consumption from single phase AC electricity net, this meter has seven digits LCD monitors shows various consumption data and information. And there are far infrared and RS485 communication module in it.
It is used for setting and reading meter, which can contact with all kind of AMR system conveniently. It has following features: good reliability, small volume, light weight, specious nice appearance, convenient installation, and etc.
Functions and Features:
＊ 35mm standard DIN rail installation, complying with standard DIN EN50022; Or front board setting (mounting holes center distance 63mm), users can choose any one by themselves;
＊ Six pole width (Modulus 12.5mm), complying with standard JB/T7121-1993;
＊ Have two tariffs, and port of set the tariff, input control voltage 0-90V, set up tariff F1, input control voltage 150-400V, set up tariff F2, the tariff conversion is controlled by timer outside or similar equipment;
＊ May select cycle display (default) or push the button itemized display, it can display 6 data at most. Can select the data which displayed. The decimal median which displayed can choose set one or two;
＊ Use memory that is not lost easily, the data can be kept forever after power cut off;
＊ A port of pulse output passive (polarity), complying with standard IEC 62053-31;
＊ Six LED indicator respectively power state, signal of power consumption. It is nothing with direction of the trend of load current. Complying with IEC 62053-21;
＊ Standard configuration don’t detect direction of the trend of load current. May select automatic detecting the direction of the trend of load current and instructions by an individual LED;
＊ Single direction measure single phase two wire active power consumption. It is nothing with direction of the trend of load current. Complying with standard IEC 62053-21.
＊ Standard configuration type S connection (Inlet from bottom, outlet from top) for direct connect to use, we can also choose another type of connection, and use CT and PT &CT for operation;
＊ Extended terminal cover, in order to protect to use electricity safely, may select short terminals cover.
|Model||Accuracy||Rated Voltage (V)||Rated Current (A)||Starting Current (A)||Insulation Performance|
|AC voltage 2kV for 1 minute, impulse voltage 6kV.|
Outer nd mount dimension: